PURSUIT 2865 DENALI Manuel du propriétaire télécharger pdf (Page 25)

2865 DENALI

Chapter 2:

HELM CONTROL SYSTEMS

2.1 General

The helm controls consist of the following: engine throttle and

shift controls, the steering system, the outdrive tilt and trim

control, and the trim tab control switches. These systems

provide the operator with the ability to control the direction

and attitude of the boat from the helm station.

Each manufacturer of the control components provides an

owner’s manual with its product. It is important that you read

the manuals and become familiar with the proper care and

operation of the control systems.

2.2 Cable Engine Throttle and Shift Controls

The shift and throttle controls on your boat may vary depending on the engine used. The

following description is typical of most cable activated inboard/outboard remote controls. Refer

to the engine or control manual for specific information on the control installed on your Denali.

The engine throttle and shift control system consists of three major components: the control

handle, the throttle cable, and the shift cable. The cables are all the push-pull type. Two cables

are required for each engine and control. One connects the remote throttle control to the engine

and the other connects the remote shift control to the outdrive shift linkage.

The helm on your Denali is designed for a binnacle style control with a single lever that

operates as a gear shift and a throttle. General operation will include a position for neutral

(straight up and down), a forward position (the 1st detent forward of neutral), and a reverse

position (the 1st detent aft of neutral). Advancing the control lever beyond the shift range

advances the throttle in forward or reverse. Each control is equipped with a means of

permitting the engine to be operated at a higher than idle RPM while in neutral for cold starting

Helm

2-1

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 174 175

Pas de commentaire

PURSUIT 2865 DENALI Manuel du propriétaire Page 25