PURSUIT S280 Manuel du propriétaire télécharger pdf (Page 33)

C 280/S 280/C 310/S 310

Chapter 4:

ELECTRICAL SYSTEM

4.1 General

Your Pursuit is equipped with a 12-volt DC electrical system and may be equipped with an AC system. The

DC system draws current from on-board batteries. The AC system draws current from shore power outlets

at dockside.

There are electrical schematics included in this manual to assist technicians in the servicing the electrical

systems. Pursuit does not recommend that you attempt to service or modify the electrical system yourself.

We recommend that you take your boat to an authorized Pursuit dealer for service or installation of additional

electrical equipment. Pursuit reserves the right to modify or update the electrical system at any time without

notice to the consumer or obligation to make updates to boats built prior to the change.

COMPARTMENTS ON A PURSUIT BOAT MAY BE LIGHTED FOR NIGHT USE. LIGHT BULBS

GENERATE HEAT AND CAN IGNITE ORDINARY COMBUSTIBLES CAUSING A FIRE. DO NOT

PLACE OR STORE COMBUSTIBLE MATERIALS IN CONTACT WITH LIGHT BULBS. TURN

OFF ALL LIGHTING PRIOR TO LEAVING THE BOAT.

4.2 DC System

BATTERIES

The 12-volt batteries in your boat have been selected to provide optimum performance for engine starting and

house and electronics loads. There are three Group 31, lead acid batteries located in the aft bilge, one for the

starboard engine, one for the port engine and a house battery. They will require similar maintenance as those

found in automobiles. A circuit breaker located on each engine protects the engine ignition systems and

gauges. Please refer to the engine owner's manual for information on the circuit breakers installed on your

engines.

DC DISTRIBUTION

The 12-volt DC system is made up of batteries that are charged by the engine charging system or by the battery

charger when connected to shore power. Twelve-volt power is distributed to the battery switches and the

breakers on the Main Distribution Panel (MDP), located in the aft starboard cockpit, that protect the switch

panels located on the helm and in the head enclosure.

Circuit protection located on each engine protects the engine ignition systems and gauges. Please refer to the

engine owner's manual for information on your engines.

PROPER FUSE OR BREAKER PROTECTION MUST BE PROVIDED FOR ALL 12-VOLT EQUIP-

MENT ADDED. DO NOT OVERLOAD THE ACCESSORY CIRCUIT BREAKERS OR OTHER CIR-

CUITRY THROUGH ADDITIONAL 12-VOLT EQUIPMENT.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 119 120

Pas de commentaire

PURSUIT S280 Manuel du propriétaire Page 33