PURSUIT S280 Manuel du propriétaire télécharger pdf (Page 93)

C 280/S 280/C 310/S 310

PREPARING THE BOAT FOR STORAGE:

• Remove the bilge drain plug(s), if installed.

• Thoroughly wash the fiberglass exterior, especially the antifouling portion of the bottom. Remove as

much marine growth as possible. Lightly wax the exterior fiberglass components.

• Remove all oxidation from the exterior hardware and apply a light film of moisture displacing lubricant.

• Remove propellers and grease the propeller shafts using light waterproof grease.

• Remove the batteries and store in a cool place. Clean using clear, clean water. Be sure the batteries have

sufficient water and clean terminals. Keep the batteries charged and safe from freezing throughout the

storage period.

• Refer to the Electrical System Chapter for information on the maintenance of the AC and DC electrical

systems.

• Coat all faucets and exposed electrical components in the cabin and cockpit with a protecting oil.

• Clean out, totally drain and completely dry the fishboxes, sinks and livewells.

• Thoroughly clean the interior of the boat. Vacuum all carpets and dry clean drapes and upholstery.

• Remove cushions, open the refrigerator/cooler door and as many locker doors as possible. Leaving as

many of these areas open as possible will improve the boat’s ventilation during the storage period.

• It is recommended that a mildew preventer be hung in the boat’s cabin before it is closed for storage.

• Clean the exterior upholstery with a good vinyl cleaner and dry thoroughly. Spray the weather covers

and boat upholstery with a spray disinfectant. Enclosed areas such as the refrigerator, shower basin,

storage locker areas, etc. should also be sprayed with this disinfectant.

12.2 Winterizing

FRESH WATER SYSTEM

The entire fresh water system must be completely drained. Disconnect all hoses, check valves, etc. and blow

all the water from the system. Make sure the water heater and fresh water tank are completely drained. Use

only very low air pressure when doing this to prevent possible system damage. Because of the check valve

mechanism built in the pump, blowing the lines will not remove the water from the fresh water pump. Remove

the outlet hose on the pump. Turn the pump on and allow it to pump out any remaining water....about a cupful.

A recommended alternative to the above-mentioned procedure is the use of commercially available nontoxic,

fresh water system antifreeze. After draining the potable water tank, lines and water heater, pour the

antifreeze mixture into the fresh water tank, prime and operate the pump until the mixture flows from all fresh

water faucets. Be sure to open all hot and cold water faucets, including the fresh water spray head in the stern

bait station sink and the water supply valve for the head. Make sure antifreeze has flowed through all of the

fresh water drains.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 119 120

Pas de commentaire

PURSUIT S280 Manuel du propriétaire Page 93