PURSUIT S280 Manuel du propriétaire télécharger pdf (Page 55)

C 280/S 280/C 310/S 310

NOTICE

T-TOP

The fiberglass T-top frame is white powder coated aluminum and is designed to accommodate radio antennas,

radar antennas and navigation lights. It is equipped with an overhead storage compartment for life jackets,

an enclosed storage compartment and overhead red and white lights. It could also be equipped with optional

outriggers and/or rod holders.

CARE SHOULD BE EXERCISED TO PREVENT DAMAGE TO POWDER COATED SURFACES.

IF THE SURFACE IS SCRATCHED, CHIPPED OR WORN EXPOSING THE ALUMINUM, IT

SHOULD BE RESEALED TO PREVENT CORROSION FROM FORMING. IF CORROSION IS

ALLOWED TO FORM, IT COULD CAUSE THE POWDER COATING TO BUBBLE AND LIFT

AWAY. CONTACT YOUR DEALER FOR REPAIR ASSISTANCE.

Radar and electronics antennas must be mounted near the center section of the T-top in the area above the legs.

Do not mount any antennas or equipment to the brow area forward of the front legs or to the rear of the top.

The T-top is not designed to support the weight of accessories in these areas.

The warranty for the T-top will be void if the top is modified in any way or heavy accessories like life rafts

are mounted to the top. Additionally, if items like radar antennas, spotlights and other accessories are

mounted in the wrong location, the warranty could be void. If you intend to add equipment or make

modifications to the T-top, you should contact Pursuit Customer Relations to make sure the equipment you

would like to add or the intended modification will not void the warranty on the T-top.

If an after market T-top is installed, it must be designed with front legs that are bolted to the console on either

side of console seat and the rear legs bolted to the cockpit sole at the rear of the console. There are aluminum

plates or wood reinforcement in the laminate in these areas for securing the T-top leg bases. Both front and

rear legs should also have brackets that are thru-bolted to the console just below the windshield to provide

additional stiffening for the T-top. If you intend to install an after market T-top on your boat, please contact

your dealer or Pursuit Customer Relations.

7.3 Tower (Dealer Installed)

Your boat could be equipped by your dealer or a fabricator with a field installed aluminum tower. Towers are

normally equipped with full engine controls, compass, engine alarms, restart buttons and tachometers. This

allows for complete operation of the boat from the tower.

TO PREVENT GEL CRACKING OR DAMAGE TO GUNWALES OR DECKS, SUPPORT EXTEND-

ING TO THE STRINGERS MAY BE REQUIRED. FIBERGLASS DAMAGE DUE TO THE AF-

TERMATH INSTALLATION OF A TOWER IS NOT COVERED BY THE PURSUIT LIMITED WAR-

RANTY.

EQUIPPING A BOAT WITH A TOWER MAY REQUIRE INSTALLATION OF LOWER PITCH

PROPS TO COMPENSATE FOR THE WIND RESISTANCE AND WEIGHT OF THE TOWER.

NOTICE

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Pas de commentaire

PURSUIT S280 Manuel du propriétaire Page 55